Table 2-1 | Power Cord Connections - Acom 700S User Manual

f) Main fuses
Please, see
Figure 2-4 | Rear panel - Connections
Make sure you check whether the main fuses installed in your amplifier correspond to
your local mains nominal voltage. If occasion should require replacement of the mains
fuses, replace them as described in Section
g) Power cord
Please, see
Figure 2-4 | Rear panel - Connections
Due to the different standards in different countries, the mains plug for the amplifier power supply cable is
supplied and mounted by the dealer. He connects to the mains cord end a standard mains supply plug
which meets the Safety Class I unit standard in your country.
The ground lead of the amplifier's power cord is colored yellow with two green stripes and the blue and
brown leads are active. When the amplifier is to be used with only one mains fuse, it is connected in series
with the brown lead, which must be the active.
N
ACOM
amplifier
L
G or PE or E
If you have any doubts about the correct way of connecting the wires, consult your dealer.
Page 26 of 92 | S e c t i o n INSTALLATION
, Pos. (f).
, Pos. (g).

Table 2-1 | Power cord connections

Wire name
Neutral
Line, Active, Live
Ground (Protective Earthing conductor)
Table 2-1 | Power cord connections
User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
NOTICE
7.3 Fuse Replacement
Description
!
Colors
Blue
Brown
Yellow - Green
April 2024