Acom 700S User Manual page 17

User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
PRECAUTIONS:
For safe operation, the amplifier's grounding stud on the rear panel (marked GND, see
Figure 2-4 | Rear panel - Connections
standards and local regulations for electric safety, fire safety and lightning protection, in
all cases when the radio station is equipped with outdoor antenna(s)!
NEVER underestimate the danger of lightning!
To prevent accidents, connection/disconnection to the grounding and antennas should
only be carried out in clear, quiet, and sunny weather when there is no danger of
lightning and static discharges.
Both the mains voltage and the high DC voltage up to 500 V inside the ACOM 700S
amplifier are LETHAL!
For your safety, pull the amplifier power plug out of the mains wall outlet and WAIT AT
LEAST 3 minutes EACH TIME BEFORE you remove the cover of the amplifier.
Never allow anyone, ESPECIALLY CHILDREN, to push or put anything into holes in the
case - this will cause electric shock. NEVER TOUCH AN ANTENNA or antenna insulators
during transmission or tuning - this may result in an electric shock or burn. NEVER
EXPOSE the amplifier to rain, snow, or any liquids. AVOID placing the amplifier in
excessively dusty environments or in direct sunlight. DO NOT OBSTRUCT COOLING ducts
or vents. Keep a minimum clearance distance of 10 cm (4 inches) to any other devices or
objects.
To avoid damage (not covered under warranty) read the Section
User's Manual carefully. Installation of the equipment must comply with local and
national electrical codes.
If you have any doubts about the installation, operation, or safety of the amplifier,
please, consult your dealer.
April 2024
DANGER
) should be connected according to the applicable
DANGER
DANGER
DANGER
WARNING
S e c t i o n GENERAL INFORMATION | Page 17 of 92
of this
2 INSTALLATION