Dhcp Client Ifconfig - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

dhcp client ifconfig

Show/set the configuration of DHCP lease created for a specific interface.
Execute the dhcp client ifrelease command before configuring the dhcp client.
Note
SYNTAX:
dhcp client ifconfig
intf
[clientid]
[hostname]
[addr]
[leasetime]
[addrtrans]
[dns]
[gateway]
[metric]
E-SIT-CTC-20021203-0003 v1.0
intf = <interface name>
[clientid = <{client-id|none}>]
[hostname = <hostname|"">]
[addr = <ip-address>]
[leasetime = <number>]
[addrtrans = <{none|pat}>]
[dns = <{off|on}>]
[gateway = <{off|on}>]
[metric = <number{0-100}>]
The name of the dynamic interface to be configured.
The client identity to be associated with the lease. Use none in case
no clientid should be associated with this lease.
The host name of the client to be associated with the lease. Use "" in
case no hostname should not be associated with this lease.
The preferred dynamic IP address.
A number between 0 and 1814400 (seconds).
Represents the preferred time the client wants to use an address.
By default the leasetime is 7200 seconds (2 hours).
Specifying -1 makes the lease permanent.
Automatically enable address translation for this dynamic interface
(pat) or not (none).
Request (and accept) DNS server IP addresses (on) or not (off).
Request (and accept) gateway IP addresses (on) or not (off).
A number between 10 and 100000.
Represents the gateway route metric
By default the gateway route metric is 1.
DHCP Commands
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
73