Basic Navigation And Manipulation - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

Basic Navigation and Manipulation

Manipulation commands are commands that manipulate operations on the command line, for example changing the
command group, go to the beginning of the command line, go to the end of the command line, etc.
Command group Navigation
From top level, you can change to a command group by executing the name of the desired command group.
To obtain a list of all available command groups, execute help from the top level.
The example below shows every possible CLI command group for the SpeedTouch
=>help
Following commands are available :
help : Displays this help information
menu : Displays menu
? : Displays this help information
exit : Exits this shell.
.. : Exits group selection.
saveall : Saves current configuration.
Following command groups are available :
adsl atm
dhcp dns
ip ipoa
phonebook ppp
system td
=>
However:
eth is only available on SpeedTouch
•
TM
SpeedTouch 530
upnp is only available for the SpeedTouch
•
wireless is only available for the SpeedTouch
•
To return to top level, or to descend one level (in case of nested command groups) execute .. .
EXAMPLE:
=>phonebook
[phonebook]=>
[phonebook]=>..
=>
12
bridge cip
env eth
mer nat
pptp qosbook
upnp
TM
510 variants equipped with a single Ethernet port and the
TM
510 variants and the SpeedTouch
TM
570
TM
510.
config
firewall
password
software
TM
530
E-SIT-CTC-20021203-0003 v1.0