SYNTAX:
bridge ifadd
[intf]
[dest]
EXAMPLE:
=>bridge iflist
OBC
:
Internal
Connection State: connected
RX bytes:
TX bytes:
eth0
:
Internal
Connection State: connected
RX bytes:
TX bytes:
usb_bridge :
dest : usb_port
Retry : 10
Connection State: connected
Port: wan2
RX bytes: 0
TX bytes: 0
=>bridge ifadd intf=TestBridge dest=Br1
=>bridge iflist
OBC
:
Internal
Connection State: connected
RX bytes:
TX bytes:
eth0
:
Internal
Connection State: connected
RX bytes:
TX bytes:
usb_bridge :
dest : usb_port
Retry : 10
Connection State: connected
Port: wan2
RX bytes: 0
TX bytes: 0
TestBridge :
dest : Br1
Retry: 10
Connection State: not-connected Port: (Unassigned)
=>
E-SIT-CTC-20021203-0003 v1.0
[intf = <string>]
[dest = <available ETHoA phonebook entries>]
The bridged Ethernet interface name.
If not specified, the destination parameter must be specified. In this
case the name of the destination will double as interface name.
The destination address for the new interface.
Typically a phonebook entry. Browse through the available entries via
the ARROW UP and ARROW DOWN keys.
Port: OBC
75783
frames:
572
82768372
frames:
341221
Port: eth0
156344216 frames:
5899238
75689
frames:
425
QoS : default
Encaps : llc/snap
PortNr: 4
PortState: forwarding
frames: 0
frames: 0
Port: OBC
75783
frames:
572
82843610
frames:
341554
Port: eth0
156472129 frames:
5903256
75689
frames:
425
QoS : default
Encaps : llc/snap
PortNr: 4
PortState: forwarding
frames: 0
frames: 0
QoS: default
Encaps: llc/snap
PortState: forwarding
dropframes:
0
PortState: forwarding
dropframes:
5558017
Fcs : off
dropframes: 0
PortState: forwarding
dropframes:
0
PortState: forwarding
dropframes:
5561702
Fcs : off
dropframes: 0
Fcs: off
PortState: forwarding
Bridge Commands
OPTIONAL
OPTIONAL
37
Need help?
Do you have a question about the SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 and is the answer not in the manual?