Ip Config - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

ip config

Show/set global IP stack configuration options.
SYNTAX:
ip config
[forwarding]
[firewalling]
[redirects]
[sourcerouting]
[netbroadcasts]
[ttl]
E-SIT-CTC-20021203-0003 v1.0
[forwarding = <{off|on}>]
[firewalling = <{off|on}>]
[redirects = <{off|on}>]
[sourcerouting = <{off|on}>]
[netbroadcasts = <{off|on}>]
[ttl = <number{0-255}>]
[fraglimit = <number{1-1024}>]
[defragmode = <{normal|always|nat}>]
[addrcheck = <{off|own|static|dynamic}>]
[mssclamping = <{off|on}>]
Disable (off) or enable (on) the IP routing functionality.
Enable (on) or disable (off) IP firewalling (master switch).
If applicable the CLI firewall level allows configuration of the Speed-
TM
Touch firewall.
For security reasons this parameter is enabled per default.
It is strongly recommended never to disable the SpeedTouch
wall.
Disable (off) or enable (on) the sending of ICMP redirect messages.
A router can send a redirect message in case a shorter path than
the path followed is discovered.
For security reasons this parameter is disabled per default.
Disallow (off) or allow (on) IP source routed packets.
IP source routed packets are packets with the route to follow speci-
fied in the header.
For security reasons this parameter is disabled per default.
Disallow (off) or allow (on) net directed broadcasts.
This parameter is per default disabled.
In case netbroadcasts are allowed no traces of netbroadcasts are
generated.
A number between 0 and 255.
Represents the default time-to-live (ttl) for locally generated IP
packets. This parameter determines the number of hop-counts the
IP packet may pass before it is dropped.
Generally the time-to-live is 64 hop-counts.
By limiting the time-to-live continuous circulation of IP packets on
the network without ever reaching a destination is avoided.
IP Commands
OPTIONAL
OPTIONAL
TM
fire-
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
165