THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual page 240

PPP Commands
[srcmsk]
[metric]
EXAMPLE:
=>ppp iflist
PPP1: dest : PVC3
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
user name = guest
admin state = down
LCP : state = initial
IPCP: state = initial
=>ppp rtadd intf=PPP1 dst=172.16.0.5 dstmsk=24 src=10.0.0.2 srcmask=24
=>ppp iflist
PPP1: dest : PVC3
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
route = 10.0.0.2/24 - 172.16.0.5/24 (metric 1)
user name = guest
admin state = down
LCP : state = initial
IPCP: state = initial
=>
RELATED COMMANDS:
ppp rtdelete
236
The source IP mask.
Depending on the source netmask:
Everybody is allowed to use this Routed PPP(oA/oE) connection
•
(dstmsk=0)
Only members of the same subnet as the host which opened the
•
Routed PPP(oA/oE) connection are allowed to use the Routed
PPP(oA/oE) connection (dstmsk=1)
The actual destination mask will be the netmask applicable for the IP
•
address of the host which opened the Routed PPP(oA/oE) connec-
tion.
Only the host which opened the Routed PPP(oA/oE) connection is
•
allowed to use the Routed PPP(oA/oE) connection. (dstmsk=32)
Any valid (contiguous) netmask in case of VLSM.
•
The route metric, i. e. the cost factor of the route.
Practically, the cost is determined by the hop count.
It is recommended not to use this parameter.
Note
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
Delete the route specification for an upcoming Routed PPP(oA/oE) link.
LLC
addr route savepwd
link state = not-connected
term. reason =
term. reason =
LLC
addr route savepwd
link state = not-connected
term. reason =
term. reason =
OPTIONAL
OPTIONAL
PPPOE
PPPOE
E-SIT-CTC-20021203-0003 v1.0