System Config - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

system config

TM
Show/set SpeedTouch
For a good operation of Universal Plug and Play (UPnP) and the discovery mechanism, it is highly recom-
Note
mended not to change the System config settings.
SYNTAX:
system config
[upnp]
[mdap]
[dcache]
EXAMPLE:
=>system config
upnp discovery: on
mdap discovery: on
dcache: on
=>
Please do not change the System config settings. In case of Setup Wizard discovery problems, check
Note
whether the System config settings are listed as in the example above. If needed, execute the System config
command as listed in the example below:
E-SIT-CTC-20021203-0003 v1.0
system configuration parameters.
[upnp = <{disabled|enabled}>]
[mdap = <{disabled|enabled}>]
[dcache = <{disabled|enabled}>]
Enable (enabled) or disable (disabled) Universal Plug and Play (UPnP)
discovery.
By default UPnP discovery is enabled.
Enable (enabled) or disable (disabled) proprietary discovery
protocol.
By default MDAP discovery is enabled.
Enable (enabled) or disable (disabled) data cache.
By default data cache is enabled.
For internal use only. Do not alter in any way.
System Commands
OPTIONAL
OPTIONAL
OPTIONAL
261