Dhcp Server Spoof - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

DHCP Commands

dhcp server spoof

Show/set DHCP spoofing parameters. Only applicable in case of a PPP-to-DHCP Spoofing connection. (See dhcp server
config command).
SYNTAX:
dhcp server spoof
[failtime]
[errorlt]
[dodlt]
EXAMPLE:
=>dhcp server spoof failtime=8 errorlt=120 dodlt=20
=>dhcp server spoof
Failure timeout (!DoD):
Failure lease time (!DoD): 120 sec
Temp. lease time (DoD):
=>
RELATED COMMANDS:
dhcp server policy
dhcp server stats
86
[failtime = <number>]
[errorlt = <number>]
[dodlt = <number>]
A number between 0 and 1814400 (seconds).
Represents the time to wait for a PPP link to successfully negotiate
an IP address.
This parameter determines how long the SpeedTouch
to set up a PPP connection before returning to normal DHCP mode,
i.e. in case the PPP connection cannot be established within the time
lapse determined by failtime, the SpeedTouch
allocate an local private IP address to the DHCP client.
By default the failtime is 4 seconds.
A number between 0 and 1814400 (seconds).
Represents the leasetime of the private address issued when a PPP
link fails.
In case the PPP link fails after failtime has elapsed, this parameter
determines how long the private DHCP lease must be maintained
before retrying to set up the PPP link again.
By default the error lease time is 60 seconds.
A number between 0 and 1814400 (seconds).
Represents the leasetime of the temporary private IP address in case
of a dial-on-demand PPP link.
In case of a dial-on-demand PPP link, this parameter determines the
interval at which the the temporary DHCP lease must be maintained
before checking whether a public IP address negotiated by a trig-
gered PPP link is available.
By default the dial-on-demand lease time is 10 seconds.
8 sec
20 sec
Set DHCP server policy.
Show current DHCP server state and statistics.
TM
should try
TM
DHCP server will
E-SIT-CTC-20021203-0003 v1.0
OPTIONAL
OPTIONAL
OPTIONAL