Ppp Rtadd - THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual

ppp rtadd

Automatically add a route configuration to the routing table in case the specified Routed PPP(oA/oE) interface link
comes up.
This route configuration will determine which local hosts are allowed to use this link and/or which remote destinations
should be or should not be reachable.
Execute the ppp ifdetach command for this interface prior to configuring routes.
Note
SYNTAX:
ppp rtadd
intf
dst
[dstmsk]
[src]
E-SIT-CTC-20021203-0003 v1.0
intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
The name of the Routed PPP(oA/oE) interface.
The destination IP address for the route to be added when the link comes
up.
The destination IP mask.
Depending on the destination netmask:
Any remote destination is reachable, i.e. the Routed PPP(oA/oE)
•
connection acts as default route (dstmsk=0)
Only the remote (sub)net is reachable (dstmsk=1)
•
The actual destination mask will be the default netmask applicable
•
for destination IP address
Only the single remote host is reachable (dstmsk=32)
•
Any valid (contiguous) netmask in case of Variable Length Subnet
•
Masking (VLSM).
The source IP address specification for the route to be added when the
link comes up.
PPP Commands
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
235