THOMSON SPEEDTOUCH 510I - REFERENCE GUIDE RELEASE 4.0 Reference Manual page 231

[accomp]
[trace]
[pap]
[restart]
[retryinterval]
[passive]
[silent]
[echo]
[mru]
[laddr]
E-SIT-CTC-20021203-0003 v1.0
Try (on), do never try (off) or negotiate (negotiate) to negotiate PPP
address & control field compression (LCP ACCOMP).
In the very most cases LCP ACCOMP should not be disabled nor negoti-
ated, i.e. the address field FF-03 should not be sent over ATM. Therefore
by default this parameter is enabled (on).
In case the accomp parameter is set 'negotiate' the local side of the PPP
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
Enable (on) or disable (off) verbose console logging.
By default tracing is disabled (off).
Select the authentication protocol.
Choose between:
on: Password Authentication Protocol (PAP) authentication will be
•
forced, CHAP authentication is not allowed
off: Challenge Handshake Authentication Protocol (CHAP) authenti-
•
cation will be used if available, PAP will be used in cases where
CHAP is not available.
For security reasons PAP negotiation is disabled (off) per default.
Automatically restart the connection when Link Control Protocol (LCP)
link goes down (on) or do not restart automatically (off).
By default restart is disabled (off).
A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level..
Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open
to wait for incoming messages from the remote side after 10 unsuccessful
tries to establish the connection or not.
Per default the listening state is disabled.
Do not send anything at startup and just listen for incoming LCP messages
(on) or retry up to 10 times to establish the connection (off).
Per default the silent state is disabled.
Send LCP echo requests at regular intervals (on) or not (off).
Per default the sending of LCP echo requests is enabled.
A number between 293 and 8192.
Represents the maximum packet size the SpeedTouch
to be able to receive.
The local IP address of the peer-to-peer connection.
Specifying a local IP address forces the remote side of the PPP link (if it
allows to) to accept this IP address as the SpeedTouch
address.
If not specified, the SpeedTouch
Typically the local IP address parameter is not specified.
TM
TM
TM
will accept any IP address.
PPP Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
should negotiate
OPTIONAL
PPP session IP
227