Commissioning The Device And Device Functions; General Information On Commissioning; Switching The Device On/Off - Siemens SIMATIC IPC227G Operating Instructions Manual

Commissioning the device and device functions

4.1

General information on commissioning

Danger of burns
The surface of the device can reach temperatures of over 65 °C. Any unprotected contact
may cause burns.
Avoid direct contact during operation of the device. Touch the device only with appropriate
protective gloves.
Note
Configuring memory cards in the device
Memory cards used in a device need to be configured on that device. Memory cards
configured on other devices will not boot as the drive parameters will be different.
Requirement
• The device is connected to the power supply.
• The protective conductor is connected.
• The connection cables are plugged in correctly.
• The following hardware is available for initial commissioning:
– One USB keyboard
– One USB mouse
– A monitor/display
4.2

Switching the device on/off

For the configuration with operating system pre-installed, the operating system is set up
automatically on the device after the initial switch-on. The commissioning procedure in this
chapter is only applicable to the IPCs with operating system.
For the configurations without operating system pre-installed, contact the operating system
provider to install the operating system first.
SIMATIC IPC227G
Operating Instructions, 06/2021, A5E50059933-AA
CAUTION
4
35