Displaying A Single Source; Displaying Multiple Sources: Stitched Layouts - Barco HDX-4K20 FLEX User Manual

GUI – Source

10.1 Displaying a single source

About selecting a source
Before a source can be projected, the source signal must be connected to the source input(s) of the device
and a valid synchronization signal must be available along with the source signal on at least one of the input
connectors.
How to select?
1. Press Menu to activate the menus and select Source.
Image 10–1 Main menu, Source
2. Press OK.
The Select Source menu is displayed with the actual available sources filled out.
Image 10–2 Example of the input selection menu
3. Select the desired input.

10.2 Displaying multiple sources: Stitched layouts

About stitched layouts
The first time you use a selected single source, the source will be displayed in the projector's native resolution.
If the resolution of the source is different to the projector's resolution, the image is stretched or shrunk.
It is however possible to configure and display two or four source signals to make up one single image in full
native resolution. This is called a Stitched Layout: the sources are stitched together.
The following table lists which stitched layouts you can use, and in which display mode these layouts can be
used.
100 R5906070 /16 HDX 4K