Step 23. Install Options; Gauge Rollers - MacDon A30-S Unloading And Assembly Instructions

STEP 23. INSTALL OPTIONS

A. GAUGE ROLLERS
a. Unpack gauge roller bundle.
b. Remove two locking pins (A) from each
assembly.
c. Remove nuts, bolts, and clips (B) from
assembly.
d. Insert tabs on roller assembly into slots (C) on
cutterbar at outboard mounting locations on
frame, and secure to support bracket with
locking pin (A) at lowest position.
169001
UNLOADING AND ASSEMBLY
B
A
C
B
A
e. Attach clips (B) with bolts and nuts removed at
step c. to secure roller assembly to cutterbar.
f. Tighten nuts.
Use a socket and ratchet wrench to
access the nuts.
g. Remove locking pin (A), and adjust rollers to
desired height. Re-install both locking pins (A).
D
h. Ensure that nut (D) on each pin registers in
adjacent hole in support bracket.
i. Secure pins with hairpins (E).
j. Repeat above steps for opposite side. Set both
gauge rollers to the same position.
32
NOTE
E
A
Revision E