MacDon A30-S Unloading And Assembly Instructions page 26

Pull-type mower conditioner

Hide thumbs Also See for A30-S:

Table of Contents

Connect the mower conditioner wiring harness

connector (E) to tractor. Connector is designed

to fit tractors equipped with a round 7-pin

receptacle (SAE J560).

IMPORTANT

Older model tractors will have Pin #4 (F)

energized as an accessory circuit. The

mower conditioner uses this pin position

(G) for brake lights. Check that Pin #4 in

the tractor receptacle is not constantly

energized - see your tractor operator's

manual, and if required, remove the

appropriate fuse.

169001

UNLOADING AND ASSEMBLY

Revision E

Table of Contents

A30-d