MacDon A30-S Unloading And Assembly Instructions page 54

Pull-Type Mower Conditioner Model A30-S and A30-D Pre-Delivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. See the Unloading and Assembly
Instructions for details. The completed Checklist should be retained either by the Operator or the Dealer.
CAUTION: Carefully follow the instructions given. Be alert for safety related messages which bring
your attention to hazards and unsafe practices.
Windrower Serial Number: _______________________ APT Serial Number: ____________________________

Check for shipping damage or missing parts. Be sure all shipping dunnage is removed.
Check for loose hardware. Tighten to required torque if applicable.
Check sickle drive belt tension.
Check reel drive belt and chain tension.
Check auger drive belt and chain tension.
Check reel tine to header pan clearance.
Check header angle to middle of adjustment range.
Check header flotation: 70 lbf (311 N).
Check conditioner roll gap and timing.
Check lean bar is adjusted at a setting appropriate for first crop.
Check skid shoes are evenly adjusted at a setting appropriate for first crop.
Check sickle drive box lube level and breather position.
Check tire pressure: 30 psi (207 kPa).
Check wheel bolt torque: 120 ft·lbf (160 Nm). If roading machine, re-torque wheel bolts after 1 hour.
Check hydraulic oil level at sight gauge on side of APT.
Check rear and side forming shields evenly set to desired position.
Grease all bearings and drivelines.
Check gearbox lube level.
Check roll intermesh hardware is securely tightened.
Check hydraulic hose and wiring harness routing.
RUN-UP PROCEDURE
Check hydraulic hose and wiring harness routing for clearance when raising or lowering header.
Check speed of sickle drive box pulley: 770 rpm.
Check running lights, amber hazard and signal lights are functional.
POST RUN-UP CHECKS. STOP ENGINE.
Check for hydraulic leaks.
Check belt and chain drives for idler alignment and heated bearings.
Check knife sections for discoloration caused by misalignment of components.
Check auger stripper bar clearance.
Check manuals in manual case.
Date Checked: _________________________
169001
ITEM
Checked by: _____________________________________
PAGE
---
5
44–45
44–45
44–45
46
30
46
47
31
48
31
---
13
17
28–29
35–43
40, 41
47
17
49
17
49
48
---
44–45
---
46
50
Revision E