Step 24. Lubricate Mower Conditioner - MacDon A30-S Unloading And Assembly Instructions

STEP 24. LUBRICATE MOWER
CONDITIONER
WARNING
To avoid bodily injury or death from
unexpected start-up or fall of raised
machine, stop engine, remove key and
engage lift cylinder stops before going
under machine for any reason.
The mower conditioner has been lubricated at
the factory. However, lubrication of the mower
conditioner is recommended prior to delivery to
offset the effects of weather during outside
storage and transport, and to familiarize the
Dealer with the machine.
MODEL
A30-S
A30-D
169001
UNLOADING AND ASSEMBLY
HEADER DRIVE HAY CONDITIONER
36–37
38–39
Refer to the following table and illustrations on
the following pages for lubrication points.

Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.

Inject grease through fitting with grease gun
until grease overflows fitting, except where
noted.

Leave excess grease on fitting to keep out
dirt.

Replace
immediately.

If fitting will not take grease, remove and
clean
passageway. Replace fitting if necessary.
APPLICABLE PAGE NUMBERS
40
41
35
any loose or
thoroughly. Also
CARRIER
42
broken fittings
clean lubricant
APT
43
Revision E