MacDon A30-S Unloading And Assembly Instructions page 31

F
e. Locate adjuster bars (F) through openings (K) in
forming shield.
E
L
F
f. Secure bars (F) to brackets on side deflectors
with bolts (E), washers (L), and nuts.
IMPORTANT
To avoid binding with deflectors at full
outboard position, bar (F) and washers (L)
must be re-installed exactly as shown.
169001
UNLOADING AND ASSEMBLY
K
E
L
F
g. Secure each adjuster bar (F) to forming shield
with pin (M) and hairpin. Use same hole location
on both sides.
O
h. Adjust fluffer shield (N) to middle position.
Loosen bolts (O) if required.
29
M
F
N
Revision E
O