MacDon A30-S Unloading And Assembly Instructions page 24

II. ATTACH MOWER CONDITIONER TO
TRACTOR
CAT. II and IIIN
CONFIGURATION
A
C
B
a. Position tractor, and align tractor hitch arms (A)
with hitch adapter (B).
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Stop engine, and remove key.
c. Remove pins (C) from hitch adapter, and use
the jack to adjust height of APT so that pins (C)
can be re-installed.
If tractor is equipped with a quick hitch
system, pins (C) do not need to be
removed.
d. Secure pins (C) with lynch pins.
e. Install anti-sway bars on tractor hitch to stabilize
lateral movement of hitch arms (A). Refer to
your tractor operator's manual.
TRACTOR AXLE
D
169001
UNLOADING AND ASSEMBLY
NOTE
R85 APT
E
X
f. Check distance 'X' between tractor PTO shaft
(D) and implement input shaft (E) (without the
front half of the driveline attached).
g. The measurement
dimensions listed below.
DRIVELINE SHAFT SIZE
1-3/8 in. (34 mm)
1-3/4 in. (43 mm)
h. Position driveshaft (F) onto tractor PTO shaft.
Driveline should be approximately level.
Front half of driveline (F) for 3-point hitch
is longer than the driveline for draw-bar
hitch. Ensure proper length driveline is
used.
i. Pull back collar on driveshaft, and push
driveshaft until it locks. Release collar.
j. Rotate driveline storage hook (G) to upward
position.
J
H
k. Raise jack (H), pull pin (J), and move jack to
storage position on side of APT. Secure jack
with pin (J).
22
must not exceed
DISTANCE
27 in. (685 mm)
31 in. (790 mm)
G
F
IMPORTANT
J
Revision E
the
'X'