Skid Shoes; Stub Guards - MacDon A30-S Unloading And Assembly Instructions

B. SKID SHOES
a. Unpack skid shoe bundle.
B
b. Remove two clevis pins (A) from each skid shoe.
c. Remove nuts, bolts, and clips (B) from skid
shoe.
C
d. Position skid shoe below cutterbar, and insert
tabs on skid shoe into slots (C) in frame. Secure
with clevis pin (A).
169001
UNLOADING AND ASSEMBLY
A
A
e. Attach clips (B) with bolts and nuts removed at
step c. to secure skid shoe to cutterbar.
Use a socket and ratchet wrench to
access the nuts.
f. Tighten nuts.
g. Remove clevis pin (A), and adjust skid shoe to
desired height. Re-install two clevis pins (A), and
secure with lynch pins.
h. Repeat above steps for opposite side. Set both
skid shoes to the same position.
C. STUB GUARDS
Refer to installation and adjustment instructions
in the kit.
33
B
A
NOTE
Revision E