Step 15. Install Roll Opener Links - MacDon A30-S Unloading And Assembly Instructions

STEP 15. INSTALL ROLL OPENER
LINKS
A
a. Remove banding
opener arm (A) to rear link (B).
A
LOOKING FORWARD AT LH LINK
RH OPPOSITE
b. Attach head (hook end) of roll opener arm (A) to
rear link (B) with bolt (C) that was removed in
STEP 8a. Do not over-tighten locknut. Links
must pivot freely at (C).
IMPORTANT
Joggle in rear links (B) must face
outboard.
c. Remove bolt (D) from roll lift arm (E) on header,
and attach ball joint end of opener arm at this
location. Tighten securely.
169001
UNLOADING AND ASSEMBLY
B
securing conditioner
C
D
E
B
roll
d. Attach lower end of rear link (B) to arm (F) with
bolt (G) that was removed in STEP 8a. Torque
to 150 ft·lbf (203 N·m).
e. Repeat above steps for opposite side.
27
B
G
F
Revision E