MacDon A30-S Unloading And Assembly Instructions page 47

II. A30-D DOUBLE KNIFE
a. Open shield on header RH side.
C
b. Reel drive belt (A) should deflect 3/16 in.
(4 mm) when a load of 8–12 lbf (35–40 N) is
applied to each belt at mid-span.
c. Reel drive chain (B) slack should be 1/4 in.
(6 mm).
d. Sickle drive belt (C) should deflect 11/20 in.
(14 mm) when a load of 5–6.5 lbf (22–30 N) is
applied at mid-span).
e. Close shield.
f. Open shield on header LH side.
D
g. Sickle drive belt (D) should deflect 11/20 in.
(14 mm) when a load of 5–6.5 lbf (22–30 N) is
applied at mid-span).
h. Auger drive chain (E) deflection should be
1/4 in. (6 mm).
i. Auger drive belts (F) should deflect 3/16 in.
(4 mm) when a load of 8–12 lbf (35–40 N) is
applied to each belt at mid-span.
j. Close shield.
169001
PRE-DELIVERY CHECKS
B
A
F
E
45
Revision E