Step 12. Install Forming Shield - MacDon A30-S Assembly Instructions Manual

STEP 12. INSTALL FORMING
SHIELD
a. Remove the header from the windrower (if
attached) for ease of installation of the forming
shield.
Do not install the two triangular shaped
plates.
A
b. Install bolt (A) with spacer (B), and nut on each
leg in the upper hole. Hardware is supplied with
forming shield kit.
C
c. Remove the two clevis pins (C) from "forward
end" of forming shield.
d. Position forming shield under the windrower
frame.
Form 169078
UNLOADING AND ASSEMBLY
NOTE
B
e. Locate forming
windrower legs, and secure with clevis pins (C)
and lynch pin.
D
f. Lift the aft end of the forming shield, and attach
straps (D) to pins (E) on windrower frame.
Install washer and hairpin to secure strap. Use
the middle hole, and adjust height to suit the
crop.
17
C
A
shield onto bolts (A)
E
(continued next page)
Revision C
in