Step 20. Install Forming Shield; Install Supports; Attach Forming Shield - MacDon R80 Unloading And Assembly Instructions

STEP 20. INSTALL FORMING
SHIELD
A. INSTALL SUPPORTS
a. Remove supports and hardware bag that were
removed from shipping locations in earlier
steps.
b. Remove protective moulding from behind
cutterbar doors (2 places).
LH
c. Insert support from rear of header as shown.
The supports are handed and lower flanges
must face each other.
Form # 169080
UNLOADING AND ASSEMBLY
d. Locate support (A) on outboard side of mounting
e. Retrieve two ½ x 1.0 lg. carriage bolts (C) and
f.
B. ATTACH FORMING SHIELD
a. Place forming shield on lift forks and position
b. Slide forming shield onto supports and back fork
RH
c. Locate shield to align holes in forward row. Install
31
C
A
bracket (B).
locknuts from hardware bag and secure suppport
to bracket. Do not fully tighten bolts.
Repeat for other support.
forming shield adjacent to supports.
lift away.
four 3/8 x 0.75 lg. bolts and nuts in forward row at
locations (D) to hold shield. Nuts on inside. Do
not tighten.
B
D
(continued next page)
Model Year - 2010