Step 13 Install Forming Shield - MacDon A30-S Assembly Instructions Manual

STEP 13 INSTALL FORMING
SHIELD
a. Remove the header from the tractor if attached
for ease of installation of the forming shield.
A
b. Install bolt (A) with spacer (B), and nut on each
leg in the upper hole. Hardware is supplied with
forming shield kit.
C
c. Remove the two clevis pins (C) from forming
shield forward end.
C
A
d. Position forming shield under the tractor frame.
e. Locate forming shield onto bolts (A) in tractor leg
and secure with clevis pins (C) and hairpin.
Form # 169078
UNLOADING AND ASSEMBLY
B
D
f. Lift the aft end of the forming shield and attach
straps (D) to pins (E) on tractor frame. Install
washer and hairpin to secure strap.
middle hole and adjust height to suit the crop.
G
g. Set forming shield side deflectors to desired
width by repositioning adjuster bars (F).
same hole location on both sides.
h. Adjust fluffer shield (G) to middle position.
Loosen handles (H) if required.
15
E
BOTH SIDES
H
Model Year - 2009
Use the
F
Use