Table of Contents
Advertisement
2.08
Generator Recommendations
When using generators to power the CM40 Plasma Cutting System, the following ratings are a
minimum and are to be used along with the ratings previously listed.
Generator Output Rating
NOTE: If Generator is equipped with an idle mode it will need to be in "Run" mode to operate at 40 amps.
NOTE!
Due to circuitry, age and condition two generators with the same ratings may produce different results. Adjust the
amperage accordingly.
Recommended
1/2"
2.09
Power Supply Features
Art # A-14041
0-5570
CM 40 Generator Specifications
CM 40 Output Current Arc Characteristic
3 kW / 120V
5 kW / 120V
6.8 kW
CM 40 Cut Capacity
(12.7mm)
INTRODUCTION
20A on 15A circuit
27A on 20A circuit
40A
Pierce
1/2"
(12.7mm)
Handle and Leads Wrap
Control Panel
Work Lead Receptacle
Torch Leads Receptacle
CUTMASTER 40
Full
Full
Full
Maximum
1" (25.4mm)
19
Advertisement
Table of Contents
