Table of Contents
Advertisement
@ Gamma correction on/off
Parameter name
Data
8. GAMMA
ON-OFF
ON:
Gamma correction on. (Gamma ratio 0.45, can be
fine-adjusted by parameter 9.)
OFF:
Gamma correction off. (Gamma ratio 1)
@ Gamma correction level
Parameter name
Data
8.GAMMA LEVEL
~98 0 9S
Co)
The gamma correction level can be set. The greater the
value, the greater the amount of correction. For accurate
adjustment, a waveform monitor, oscilloscope, or a reference
chart is necessary. Normally do not adjust this parameter.
e@ For accurate adjustment, consult an authorized JVC
Service agent.
Operation modes setting
@ Master menu (MENU)
e Parameter screen (1/2)
(2/2)
4 SET UP
@ For the procedure of selecting menus, see
e Sub-menu
-OPERATION SET- 1/2
OPERATION SET~ 2/2
page 36.
(SET UP MENU)
026: 12
§- AUTO See
UNoRM
© For the procedure of altering parameter
3 OPERATION
= AW:
OFF
1O:BATT END
:11.5V
data, see page 36.
eM: ON
© ©)
indicates
data preset prior to
:
NOB aTT
shipment.
¢ GAIN switch setting combinations
@ Filter-linked auto white balance
Parameter name
Data
Parameter name
Data
2. AW-FIL
10N
2OFF
{ON
2ON
Sensitivities available in the three switch positions can be
The filter-linked auto white balance mode can be switched
selected from among five combinations.
on or off.
.
Selected data and mode on/off
Selected data and sensitivity
White balance
mode
1OFF 20FF
1ON 20FF | 10N20N
| ose | 06:12
0:6:ALC
6:0:12
9:0:18
0
| 008
| odB | od8 |
9dB
088
Important note:
GAIN
switch
position
auTo1
| of | On | n
If the power is switched off during memory setting operations, the data being set will not be stored in the memory.
This means all parameters will require re-setting. Be sure to return to the camera signal screen before switching off the
power.
— 39 —
Advertisement
Table of Contents
