JVC GY-X1TC Instructions Manual page 11

@ [0° 120° 240°] SC phase switch
Adjusts the colour subcarrier phase of this unit in three
steps (0°, 120°, and 240°) with respect to the reference
sync signal input to connector @ in genlock operation.
@® [SC FINE] SC phase control
Fine-adjusts the colour subcarrier phase of this unit with
respect to the reference sync signal input to connector @ in
gelock operation.
@ [H] H phase control
Adjusts the horizontal sync phase of this unit with respect to
the reference sync signal input to connector @ in genlock
operation.
@ Time code display
Displays the time code or user's bits.
@® [ADVANCE] Advance button
Used to alter the data of the digit selected with button ®
@ [SHIFT] Shift button
Used to select the digit of the time code or user's bits to be
set.
@ [HOLD] Hold button ;
@® [VITC] VITC on/off switch
ON: Jo record the VITC time code.
OFF: Not to record the VITC time code.
@ [TC/UB] Display select switch
Selects the mode of the time code display@.
TC: 'To display the time code.
UB: To display the user's bits.
—10—
R (Hot)
+9 V DC
GND
L (Hot)
L (Cold)
R (Cold)
[PinNo.[ Function
1 GND
2 HOT
3 COLD
Note
Do not use connectors @ and @ at the same time, otherwise
the correct input level may not be obtained.
@ Earphone jack
Allows monitoring of the following audio signals via an
earphone:
@ Microphone input
e VTR playback audio