Opel MOVANO Owner's Manual page 82

State indicator
The status of the heater is indicated by
the colour of the light on the quick start
button.
Status
Heating mode
Heater off - control
panel on
Error - Heating mode
not available
Pre-programmed
heating mode -
Control panel in idle
state
The control panel goes into sleep mode
(display and LEDs go out) if no actions
are made on the control panel for 60
second and the heater is off.
Passive mode display
If the heater is activated by another
Webasto control panel (e.g. Telestart
or ThermoCall), the control panel is
reactivated from its idle state and the
operating mode selected by the other
control panel is shown on the display.
The display depends on the connected
heater. The display depends on the
connected heater.
80
Display
LED lighting
GREEN steady
WHITE steady Information display
The following information about the
connected heater and the control panel
RED flashing
is shown on the start-up display:
name of the control panel;
name of the connected heater;
GREEN flashing
software version of the connected
control panel;
hardware version of the connected
control panel.
The main menu is displayed after 1.5 s.
HEATING MODE
Select the "Heating" menu item in the
main menu.
Press the control button. The
operating time flashes in the display.
Turn the control button to select the
operating time "Now".
The maximum operating time can be
selected and activated by turning the
control button clockwise.
Then press the control button to
confirm the selection.
The operating time is set in "Minute"
and "Hour".
Working mode
Heating mode is started. The
Heating.
"Heating" menu item and the preset
Press the quick
remaining time appear in the display.
start button to
The quick start button lights up green.
deactivate passive
SWITCHING ON THE HEATER WITH
mode. The heater
is switched off. THE QUICK START BUTTON
The "Quick start" can be used to
activate the heating function by simply
pressing the
mode can be changed according to
your wishes.
Quick start of the water heater
The quick start button is programmed
for heating.
Press the quick start button
The heating is started. The "Heating"
menu item and the preset remaining
time appear in the display. The quick
start button lights up green.
Temperature adjustment during
heating operation
The heater is running.
Turn the control button, select the
required temperature.
Press the control button within 5
seconds to confirm your selection.
button. The operating
.