Opel MOVANO Owner's Manual page 225

Hide thumbs Also See for MOVANO:
Table of Contents

Advertisement

RECALLING THE SPEED
Once the system has been cancelled
but not deactivated, if a speed was
previously set simply press the RES
button and remove your foot from the
accelerator to recall it.
The system will be set to the last stored
speed.
Before returning to the previously set
speed, bring the speed close to that
value, then press the RES button and
release it.
WARNING The recall function must
only be used if the road and traffic
conditions so allow. Recalling an
excessively high or low speed for the
current traffic and road conditions
could cause an acceleration or a
deceleration of the vehicle. Failure to
comply with these precautions may
cause serious accidents and fatal
injuries.
SETTING THE DISTANCE
BETWEEN CARS
The distance between your vehicle and
the vehicle ahead may be set to 1 bar
(short), 2 bars (medium), 3 bars (long),
4 bars (maximum) fig. 258.
258
The distances from the vehicle ahead
are proportional to speed.
The interval of time with respect to the
vehicle ahead remains constant and
varies from 1 second (for the short
distance 1-bar setting) to 2 seconds
(for the maximum distance 4-bar
setting).
The set distance is shown on the
display by means of a dedicated icon
(or in the "Driver Assist" area).
The setting is 4 (maximum) the first
time the device is used. After the
distance has been modified by the
driver, the new distance will be stored
also after the system is deactivated and
reactivated.
To decrease the distance
Press and release the button to
decrease the distance setting
The distance setting decreases by one
bar (shorter) every time the button is
pressed.
The set speed is held if there are no
cars ahead. Once the shortest distance
has been reached, a further press of
the button will set the longest distance.
If a vehicle is detected ahead in the
same lane, travelling at slower speed,
an icon appears on the display (where
provided). The device will automatically
adjust the vehicle speed to hold the
distance setting regardless of the set
F1A0738
speed.
The vehicle holds the set distance until:
the vehicle ahead accelerates to a
speed higher than the set speed;
the vehicle ahead leaves the lane
or the detection field of the Adaptive
Cruise Control device sensor;
the distance setting is changed;
the Adaptive Cruise Control device is
deactivated/cancelled.
WARNING The maximum braking
applied by the device is limited. The
.
223

Advertisement

Table of Contents
loading

Table of Contents