Opel MOVANO Owner's Manual page 55

necessary, block the vehicle with
wedges or stones.
While tipping, the rear side panel must
not be open for any reason.
The side panel can be opened in two
ways:
RELEASE FROM THE TOP: move
the two levers ((11) fig. 77) upwards.
UNLOCKING FROM BELOW: Open
the right-hand side release lever ((8)
fig. 77) by pushing it towards the front
of the flatbed (fig. 85).
TIPPER CONTROL
46)
CONTROL WITH ELECTRIC
CONTROL UNIT
The flatbed is equipped with a battery
disconnection switch, located on the
frame under the front left side of the
flatbed (fig. 84). This can also be used
for an emergency stop: in the "ON"
position, it enables tipping; in the
"OFF" position, it disables and locks all
system functions. Always take great
care when resetting it.
For controlling the tipper with the
electronic control unit:
Turn the battery disconnection
switch lever (fig. 84) to "ON" position.
86
Raise the flatbed using the button
panel, located on its mounting in the
cab, on the left side of the driver seat.
Hold the lifting button pressed ((2)
fig. 86). While tipping, an acoustic
warning device signals the operation in
progress.
Tipping is interrupted immediately
when the up button is released. The
tipping is stopped automatically.
When unloading is finished, lower the
flatbed by holding the down button ((1)
fig. 86) pressed until the flatbed is fully
lowered and the acoustic warning turns
off.
At the end of the operation, turn
the battery disconnection switch lever
(fig. 84), to the «OFF» position and put
the button panel back in position in the
cab.
WARNING Always hold this switch
in the OFF position after each tipper
up/down operation.
PERFORMING
MAINTENANCE SAFELY
Periodically check the overall
condition of the tipper protection
devices.
Always engage the safety strut for
any work with the flatbed raised (fig. 87
F1A9010
and fig. 88). The safety strut is suitable
for operation with the tipped flatbed
to the rear and unloaded. Refer to
the "General information" section of
the chapter "Routine maintenance"
- General information for the strut
insertion operation.
Periodically check that the screws,
nuts and any connectors are properly
tightened
Only use with the recommended
compliant oils and lubricants.
Spare parts must meet the
manufacturer's requirements. Only use
original spare parts
53