Opel MOVANO Owner's Manual page 308

372
use the Allen key to tighten the three
special screws on the nuts of the
bracket fig. 373 and secure the rim;
373
fit the assembled tool fig. 365
complete with extension (B) fig. 364
on the screw(A) fig. 364 of the spare
wheel housing manoeuvring device and
turn clockwise to lift the spare wheel
back up until it is fully supported in its
housing beneath the floor pan. Check
that the notch (D) fig. 365 indicating that
306
the device is coupled appears in the
window;
check that the position of the
replaced wheel under the platform is
correct (the lifting system is equipped
with a clutch to limit the end of the
stroke, incorrect positioning may
jeopardise safety);
place the removal tools back in the
tool bag / compartment;
F1A0426 place the tool box / compartment in
its housing under the passenger seat.
270) 271)
IMPORTANT
261) Use your hazard warning lights,
warning triangle, etc. to show that your
vehicle is stationary. Passengers should
get out of the vehicle, particularly if it is
heavily loaded, and wait for the wheel to
be changed away from the traffic. Engage
the parking brake. In the event of a wheel
change on a slope or on unsurfaced
roads, put any object as stop under the
F1A0385
wheels.
262) The spare wheel supplied (for
versions/markets, where provided) is
specific for your vehicle. Therefore, it must
not be used on other models. Do not use
spare wheels of other models on your
vehicle. The wheel bolts are specific for
your vehicle: do not use them on different
models and do not use bolts from other
models on your vehicle.
263) Repair and refit the standard wheel
as soon as possible. Do not apply grease
to the bolt threads before fitting: they
could come unscrewed.
264) Use the jack only to replace wheels
on the vehicle with which it is supplied
or on other vehicles of the same model.
Never use the jack for other purposes,
such as lifting other vehicle models. Never
use the jack to carry out repairs under the
vehicle. Incorrect positioning of the jack
may cause the lifted vehicle to fall. Do not
use the jack for loads higher than the one
shown on its label.
265) Never tamper with the inflation
valve. Never introduce tools of any kind
between rim and tyre. Check the tyre and
spare wheel pressure regularly, referring
to the values shown in the "Technical
specifications" section
266) No tools other than the crank
provided should be used with the spare
wheel lifting device; it should be operated
by hand only.
267) The device should only be operated
by hand, without using any type of
tool other than the crank provided like
pneumatic or electrical screwdrivers.
268) The moving components of the jack
(screws and joints) can also cause injuries:
avoid touching them. If you come into
contact with lubricating grease, clean
yourself thoroughly.
269) At the end of the operation of
raising/locking the spare wheel, after
having checked the correct positioning
of the wheel under the platform (yellow
notch inside the window on the device),
the spanner must be extracted, taking care
not to turn it in the wrong direction (as in