Opel MOVANO Owner's Manual page 234

270
Stationary objects and vehicles
The system cannot detect the
presence of stationary objects and
vehicles if you are travelling at a speed
exceeding 60 km/h (37 mph). For
example, the system may not operate
if the vehicle ahead leaves the lane
and a car stopped on the lane ahead
of if. Pay the utmost attention at all
times and be always ready to press the
brakes if needed.
Objects and vehicles moving in
opposite or crosswise direction
The system cannot detect the
presence of objects or cars travelling in
opposite or crosswise direction fig. 271
and consequently will not be operated.
232
271
F1A0995
IMPORTANT
187) Pay the utmost attention while driving
at all times and be always ready to press
the brakes if needed.
188) The system is an aid for the driver,
who must always pay full attention while
driving. The responsibility always rests with
the driver, who must take into account
the traffic conditions in order to drive in
complete safety. The driver must always
maintain a safe distance from the vehicle in
front.
189) The device is not activated in
presence of pedestrians, oncoming
vehicles in the opposite direction of travel
or moving in the crosswise direction and
stationary objects (e.g. a vehicle standing
in a queue or a broken down vehicle).
190) The device cannot take account of
road, traffic and weather conditions and
conditions of poor visibility (e.g. fog).
191) The device does not always fully
recognise complicated driving conditions
which could cause incorrect or non-
existing determination of the safe distance
to be held.
192) The device can take the car to a
standstill but the driver must always be
ready to apply the brakes, if necessary.
WARNING
68) The system may have limited operation
or not work at all in weather conditions
F1A0731
such as: heavy rain, hail, low sun, blinded
camera, thick fog, heavy snow.
69) The camera on the windscreen must
not be covered with stickers or any other
object.
70) Operation can be adversely affected
by any structural change made to the
car, such as a modification to the front
geometry, tyre change, or a heavier load
than the standard load of the car.
71) Incorrect repairs in the zone where the
camera is mounted may interfere with its
field of vision and reduce its performance
(e.g. application of fillers or glues to
remove scratches). Go to a Dealership for
any operation of this type.
72) Do not tamper with nor operate on the
camera on the windscreen. In the case of
damage, contact a Dealership.
73) Do not wash with high-pressure jets
in the bumper lower area: in particular
do not operate on the system's electrical
connector. Do not use solvents or abrasive
paste.
74) Be careful in case of repairs and
painting in the zone around the sensor. In
the event of a frontal impact the sensor
may automatically deactivate and display
a warning to indicate that the sensor