Opel MOVANO Owner's Manual page 261

CHARGING
SYSTEM/MAINTENANCE/
CLEANING
The device is maintenance-free.
If you need to clean the device, use a
soft cloth slightly dampened with a mild
detergent solution, then wipe dry with a
dry cloth. Do not use abrasive products
or flammable substances (e.g. alcohol,
petrol or their derivatives). Do not wash
the device with water, hazard of fire or
electric shock with the risk of serious
injury or death.
WARNING Only clean the device
when it is DISCONNECTED from
both the domestic charging socket
and the charging port located on
the vehicle.
FCC (Federal
Communications
Commission)
SPECIFICATIONS
The Charge Status Control Unit
complies with Section 15 of the FCC
Regulation.
The use of the device meets the
following two requirements:
1. This device does not cause harmful
interference.
2. Correct operation of the device may
be affected by interference from nearby
electrical/electronic devices.
This device is designed to withstand
radio frequency interference (RFI),
however, some factors (e.g., high
intensity radio signals or radio
transmitters in the vicinity of the device)
may cause it to malfunction. If you find
an anomaly in the operation of the
device, contact a Dealership.
WARNING Modifications and/or repairs
made incorrectly and NOT carried
out by a Dealership will invalidate the
warranty and the above requirements.
"MODE 3" CHARGING
CABLE
(for versions/markets, where provided)
The vehicle is equipped with a "Mode
3" charging cable, fig. 296, located
inside a special container.
The "Mode 3" charging cable:
complies with EN 61851- 1, EN
62196- 1 and EN 62196- 2 standards;
can be used for a minimum
temperature of -40°C up to a maximum
temperature of +50°C.
This type of cable allows you to
connect to public alternating current
(AC) charging stations. The charging
speed may be faster than charging
through a domestic power socket.
Using this type of cable it is possible to
charge the vehicle with a current of up
to 16A.
WARNING After use, remember to
replace the protective covers on both
sides of the charging cable correctly
to prevent moisture and/or dust from
entering the cable charging port
connections.
296
"MODE 4" CHARGING
CABLE - FAST CHARGE
This can be used to charge from DC
(direct current) public charging sockets
fig. 291.
The charging cable is connected to the
charging column.
The charging procedure can be faster
than with AC charging stations.
F1A0539
259