Opel MOVANO Owner's Manual page 263

301
remove the protective cover of the
charging port and attach it to the
device;
grasp the charging connector by
the handle (A) fig. 302, remove the
protective cover (where provided) and
insert it into the charging port until you
hear the click indicating that it has been
locked;
302
if no scheduled charging has been
set (see the "Charging functions"
chapter), charging starts automatically;
check by turning on the LEDs on the
cable control unit that there are no
faults in the charging system (for more
information see "charge status control
unit" chapter in the "Power sources
that can be used - Mode 2 cable"
section). If there are no anomalies,
the green LEDs located next to the
charging port will light up momentarily.
In case of anomalies, refer to the
F1A1057
description in the "Charging system
failure" chapter in the "Power sources
that can be used - Mode 2 cable"
section.
NOTE The charging procedure is
interrupted when opening the bonnet:
a dedicated message will be shown
on the instrument panel display. The
charge will be reactivated when the
bonnet is closed correctly.
The time required to charge the high-
voltage battery depends on several
factors: for more information see the
description in the "Electric" chapter of
in the "Multimedia" section.
If the passenger compartment
preconditioning is activated, the battery
charging time will be extended. The
time required for heating/cooling the
vehicle is mainly determined by the
F1A0512
external temperature.
WARNING The maximum power
consumption of the charging port
depends on the type of contract signed
by the user, the type of cable used and
the charge level set in the multimedia
system menu.
WARNING Only use charging cables
supplied with your vehicle, or a
replacement cable recommended by
the Manufacturer.
WARNING The high-voltage battery
must be charged in accordance with
the maximum amperage rating allowed
by local and national recommendations
for charging electric vehicles.
END OF CHARGING
PROCEDURE
The charging procedure ends when
all the LEDs (A) fig. 303 or fig. 304
(according to the versions), located
next to the charging port, will light up
steady green (during the charging
phase, on the other hand, the LEDs will
light up flashing/fixed green according
to the state of charge of the battery
portion indicated by the LED. The fixed
green light indicates that the battery
portion is fully charged).
261