Opel MOVANO Owner's Manual page 150

95)
Trailer Detection
The system can detect the presence
and length of a trailer and extend the
blind spot warning zone to the length of
the trailer.
After the system detects the presence
of a trailer and the speed exceeds
10 km/h, a notification is sent to driver.
If a trailer is detected, the Rear Cross
Path function is deactivated.
The "Blind Spot" function on the
display Setup Menu can be used to
set the mode for detecting the trailer
length.
According to the set trailer length
detection mode, the corresponding
icon will be displayed:
with the "Max" setting selected.
The warning zone is set to the
maximum expected length (greater
than 9 metres);
, or
setting selected. The system will
show an icon corresponding to the
automatically detected length (3 m,
6 m, 9 m). In this case, it may be
necessary to travel at least a curve
with a 90-degree rotation to let the
system detect the length of the trailer.
Once the length has been determined,
the icon corresponding to the length
measured in metres or feet will be
148
displayed depending on the selected
unit of measurement.
If the trailer exceeds a length of 9
m, the system displays the icon
corresponding to the maximum length.
If the vehicle is stationary for more than
120 seconds, the system detects the
trailer again:
if the trailer is no longer detected, the
icon indicating the presence and length
of the trailer disappears;
when set to "Auto", if a new trailer
is detected as present, with the same
length as the previous one (with an
error of 1 m), the length icon remains
unchanged;
When set to "Auto", if a new trailer is
detected as present, with a different
length from the previous one, the
length icon is updated.
with the "Auto"
95) The system is an aid for driving the
vehicle, it DOES NOT warn the driver
about incoming vehicles outside of the
detection areas. The driver must always
maintain a sufficient level of attention to
the traffic and road conditions and for
controlling the trajectory of the vehicle.
IMPORTANT
ATTENTION ASSIST
SYSTEM (Driver fatigue)
(where provided)
This is an auxiliary driving assistance
system that detects when the driver is
tired.
ACTIVATION / DEACTIVATION
The Attention Assist system is
automatically active when the vehicle is
started.
The system is always activate and
the alerts can be deactivated in the
"Settings" menu of the multimedia
system (see "Settings" in the"Vehicle
mode" paragraph in the "Multimedia"
section) or via the instrument panel (see
"Settings" in the "Display" chapter in
the "Knowing the instrument panel"
section).
SYSTEM INTERVENTION
The system intervenes if the camera in
the middle of the windscreen fig. 180
detects that the driver is tired, based
on variations of vehicle trajectory and
getting too close to the side of the
road.