Opel MOVANO Owner's Manual page 461

operation is mandatory before you can
accept the new route.
Navigation based on dimensions
NOTE This feature only applies to
vehicles over 3,500 kg.
Vehicle dimensions are very important
for navigation planning. We want to
avoid the vehicle getting stuck in
narrow streets or passing through
unauthorised areas. Therefore, the
navigation system takes the vehicle
dimensions into account to plan the
best possible authorised route.
When you find a new destination,
you must confirm that the vehicle
specifications are correct. These
specifications must be set during the
initial vehicle configuration.
To plan a route that takes vehicle
dimensions into account, proceed as
follows:
1: Choose the new destination:
2: Select Drive.
537
3: After selecting Drive, display the
Vehicle Measurements screen. If
size, weight and maximum speed are
correct, select Confirm configuration.
NOTE If you have a trailer attached to
the vehicle, make sure that the vehicle
dimensions are included in the total
vehicle weight and length.
If the vehicle measurements are not
correct, click on the measurement
you want to change, update it, then
select OK. You can then select Confirm
Configuration.
NOTE To calculate the weight per axle,
divide the gross vehicle weight by two.
If you have a trailer attached, divide the
gross vehicle weight by three.
538
4: Select Confirm Configuration.
The Route Selection screen will be
displayed.
F1A0898
539
CHANGING YOUR ROUTE
The route options panel
When you have planned a route, select
the Route options button at the
bottom right corner of the screen to
open the Route Options Panel.
The following buttons are available in
the menu:
Route Overview
Select this button see the route in the
map view. If you are already seeing the
route overview, you can use this button
to return to the guidance view.
F1A0899
Find Alternative
You see this button when you have
planned a route. Select this button to
F1A0900
459