Opel MOVANO Owner's Manual page 64

third press: front/rear fog lights
and side lights switch off if dipped
beam headlights are off. Only front fog
lights switch off if the dipped beam
headlights are on;
fourth press: rear fog lights switch off
if dipped beam headlights are on.
104
REAR FOG LIGHT
The rear fog light button is located
on the left control panel (button (A)
fig. 104). With rear fog lights on, the
warning light on the instrument
panel will come on at the same time.
PARKING LIGHTS
These lights can be turned on only
with the ignition device at STOP or key
extracted by turning the ring on the left
stalk first to position
(where provided) and then to positions
.
The warning light on the instrument
panel turns on.
62
Repeat the same operation to switch
them off.
An acoustic warning will sound with
the parking lights on when the driver's
door is opened. The acoustic warning
switches off as soon as the driver's
door is closed.
TIMED SWITCH-OFF OF
INTERIOR/EXTERIOR
LIGHTS (FOLLOW ME
HOME)
Activation
Turn the ignition device to STOP.
Within 2 minutes pull the left stalk
in main beam headlights flashing
mode, each displacement of the stalk
F1A0689 will correspond to an increment of
30 seconds of delay on headlights
switching off up to a maximum of 210
seconds (equal to 7 flashes).
Deactivation
Keep the left stalk in high beam
headlight flashing mode for a few
seconds.
HIGH BEAM HEADLIGHTS
With ring in position
forward toward the dashboard (stable
position). The
or AUTO or
on in the instrument panel. The lights
are switched off by pulling the stalk
towards the steering wheel.
AUTOMATIC MAIN BEAM
HEADLIGHTS
(where provided)
The system controls the automatic high
beam headlights providing increased
forward lighting at night by automating
high beam control using of a digital
camera mounted on the interior rear-
view mirror.
NOTES
The Auto Dim High Beams control
can be turned on or off using
the multimedia system. Refer to
the "Settings" paragraph in the
"Multimedia" section for further
information.
Broken, muddy or obstructed
headlights and side lights of vehicles
in the field of view of the camera will
cause headlights to remain on longer
(closer to the vehicle).
To deactivate the automatic function
rotate the light switch ring to position
Flashing the headlights
To flash, the unstable position is
, push the stalk
used. Activate by pulling the lever (A)
fig. 101 or fig. 102 or fig. 103 (where
warning light switches
provided) towards you. With high beam
headlights on, the warning light
the instrument panel will come on at
the same time.
.
on