Opel MOVANO Owner's Manual page 232

driver, the new distance will be stored
also after the system is deactivated and
reactivated.
267
To decrease the distance
Press and release the button to
decrease the distance setting (B)
fig. 264.
The distance setting decreases by one
bar (shorter) every time the button is
pressed.
The set speed is held if there are no
cars ahead. Once the shortest distance
has been reached, a further press of
the button will set the longest distance.
If a vehicle shown on the instrument
panel proceeds in the same lane,
travelling at slower speed, an icon
appears on the display (where
provided). The device will automatically
adjust the vehicle speed to hold the
distance setting regardless of the set
speed.
The vehicle holds the set distance until:
230
the vehicle ahead accelerates to a
speed higher than the set speed;
the vehicle ahead leaves the lane
or the detection field of the Adaptive
Cruise Control device sensor;
the distance setting is changed;
the Adaptive Cruise Control device is
deactivated/cancelled.
WARNING The maximum braking
applied by the device is limited. The
driver may apply the brakes in all cases
if needed.
F1A9063
WARNING If the system predicts
that the braking level is insufficient to
maintain the set distance, it signals
the driver to pay attention when
approaching the vehicle ahead by
displaying an alert message on the
display. An acoustic warning is also
emitted. In this case, it is advisable to
brake immediately as necessary to hold
a safe distance from the vehicle ahead.
WARNING The driver is responsible for
ensuring that there are no pedestrians,
other vehicles or objectives along the
direction of the vehicle. Failure to
comply with these precautions may
cause serious accidents and injuries.
WARNING The driver is fully
responsible for holding a safe distance
from the vehicle ahead respecting the
highway code in force in the respective
country.
DEACTIVATION
The device is deactivated and the set
speed is cancelled if:
the (A) fig. 264 button is pressed on
the Adaptive Cruise Control;
the Speed Limiter button is pressed;
the ignition device switch is in the
STOP position;
The device is cancelled (the set speed
and distance are stored):
when the CANC button is pressed;
when the conditions shown in the
"Setting the desired speed" paragraph
occur.
If these conditions occur while the
system is decelerating with respect
to a vehicle ahead, the system could
continue the deceleration, if necessary,
also after it is cancelled or deactivated
within the minimum speed settable on
the system.
SYSTEM LIMITED
OPERATION WARNING
If the dedicated message is shown
on the display, a condition limiting the
system operation may have occurred.