Opel MOVANO Owner's Manual page 85

Turn the control button to select the
required time or "Auto".
Then press the control button to
confirm the selection.
The display is not deactivated during
active heating if the "Auto" option is
selected. The display switches off after
10 seconds when set to "Auto" if no
heater is active.
Day/night lighting setting
You can choose between daily and
night lighting for the display. If the
"Off" option is selected, the general
brightness setting is activated without
any distinction between day and night.
The "Settings" menu item has been
selected.
Turn the control button to select the
"Day/Night" menu item.
Then press the control button to
confirm the selection.
The "Off" selection is preset.
Turn the control button to set the
values for Start of Day, End of Day,
Brightness (Day), Brightness (Night).
The display shows the pre-selected
time for Day.
Then press the control button to
confirm the selection.
The display flashes "Time" for "Start
of day".
Turn the control button to select the
required "Time" of "Start of Day".
Then press the control button to
confirm the selection. The "Minute"
time for "Start of day" flashes on the
display.
"Minute" of "Start of day" is set as
"Hour" of "Start of day".
Turn the control button to select the
required "Time" for "End of Day".
Then press the control button to
confirm the selection. The "Minute"
time for "End of day" flashes on the
display.
"Minute" of "End of day" is set as
"Hour" of "Start of day".
The display shows the "Day"
brightness level.
Turn the control button to select the
required "Day" heating level.
Then press the control button to
confirm the selection. The "Night"
brightness level appears on the display.
Turn the control button to select the
required "Night" brightness level.
Then press the control button to
confirm the selection.
The "Day/night" symbol appears on
the display. The selected values have
been saved.
Calling up system information
The system information contains data
on the software and hardware version
of the control panel as well as the
designation of the connected heater.
The "Settings" menu item has been
selected.
Turn the control button to select the
"System Information" menu item.
Then press the control button to
confirm the selection. The name of the
heater appears on the display.
Turn the control button to toggle
between the heater name and the
control panel information (control panel
name, software and hardware version).
Recalling saved error message
Error messages (codes) related to
the heater and all other connected
components in case of malfunctions
are saved and displayed here. Current
error messages are also marked
with a "!". Error messages must be
acknowledged as soon as they appear
by pressing the control button. The
main menu is only displayed again after
confirmation.
The "Settings" menu item has been
selected.
Turn the control button to select the
"Error Message" menu item.
Then press the control button
to confirm the selection. The error
message (or messages) appears on the
display. "OK" appears on the display if
there is no error message. In case of
repeated error messages, all messages
83