Otto Bock C-Leg 3C98-3 Instructions For Use Manual page 42

Battery char­
ger
Battery is being charged, battery charge level is over 50%
Battery is fully charged (or connection with product is interrupted).
Take note of the confirmation signal for differentiation.
When the battery charger is connected or disconnected, a self-test is conduc­
ted and confirmed by a beep and vibration signal.
The battery is fully charged if this signal is heard.
If no signal is emitted, the connection to the product is interrupted.
16.3 Directives and manufacturer's declaration
16.3.1 Electromagnetic environment
This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
Observe the safety notices in the section "Information on proximity to certain areas" (see page 9).
Electromagnetic emissions
Interference meas­
urements
HF emissions accord­
ing to CISPR 11
Harmonics according
to IEC 61000-3-2
Voltage fluctu­
ations/flicker accord­
ing to IEC 61000-3-3
Electromagnetic interference immunity
Phenomenon
Electrostatic dis­
charge
High-frequency elec­
tromagnetic fields
Magnetic fields with
rated power frequen­
cies
Electrical fast transi­
ents/bursts
Surges
Line against line
42
Compliance
Group 1/class B
Not applicable –
power below 75 W
Product meets the
requirements of the
standard.
EMC basic standard
or
test procedure
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-8
IEC 61000-4-4
IEC 61000-4-5
Electromagnetic environment directive
The product uses HF energy exclusively for its
internal functioning. Its HF emissions are
therefore very low, and interference with neigh­
bouring electronic devices is unlikely.
Interference immunity test level
± 8 kV contact
± 2 kV, ± 4 kV, ± 8 kV, ± 15 kV air,
10 V/m
80 MHz to 2.7 GHz
80% AM at 1 kHz
30 A/m
50 Hz or 60 Hz
± 2 kV
100 kHz repetition rate
± 0.5 kV, ± 1 kV
–
–