Otto Bock C-Leg 3C98-3 Instructions For Use Manual page 30

INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
page 25).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
Product
1. Basic Mode
1
2
3
100%
1. Basic Mode
9.2 Switching MyModes using motion patterns
Information on switching
• Switching and the number of movement patterns must be activated by the O&P professional
in the adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.
If the Volume parameter is set to "0" in the Cockpit app, there are no beep signals (see
•
page 25).
Switching process
3x
à MyMode 1
4x à MyMode 2
ð
1) Position the prosthetic leg back slightly.
2) While maintaining constant contact with the floor, bounce on the forefoot a number of times in
one second depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second without lifting
the leg. Taking the weight off is no longer necessary.
→ A beep and vibration signal will occur to confirm that the movement pattern has been
recognised.
INFORMATION: If this beep and vibration signal is not emitted, the requirements
were not met while bouncing.
30
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
2. Golf
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
1s 1x
+
ð
lower edge of the screen (3).
1x 1s
ð
ð
2x à MyMode 1
3x à MyMode 2
MyMode 1
+
ð
MyMode 2
þ