Otto Bock C-Leg 3C98-3 Instructions For Use Manual page 15

6.1 Connecting the power supply and battery charger
1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, three-pin plug of the power supply to the 12 V receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger
light up (see fig. 3).
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see page 38).
6.2 Charging the prosthesis battery
2
1) Open the charging receptacle cover (open up the flap or push the
slider up).
2) Connect the charging plug to the charging receptacle of the
product.
INFORMATION: Make sure to insert it in the right direction!
A low insertion force has to be overcome during connection
so the charging plug remains reliably connected to the char­
ging receptacle.
→ A correct connection between the battery charger and the
product is indicated by feedback (see page 38).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the
battery charger turns off.
4) Disconnect the product after the charging process is complete.
INFORMATION: A low separating force between the charging
plug and charging receptacle has to be overcome to discon­
nect the plug.
→ A self-test is performed. The product is ready for operation only
after corresponding feedback (see page 41).
5) Close the charging receptacle cover.
3
15