Supermicro X13DEG-PVC User Manual page 40

Super X13DEG-PVC User's Manual
Preparing to Install the PHM into the CPU Socket
After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below.
1. Locate four threaded fasteners (marrked a, b, c, d) on the CPU socket.
d
2. Locate four peek nuts (marked A, B, C, D) and four rotating wires (marked 1, 2, 3, 4) on
the heatsink as shown below.
A, B, C, D: PEEK Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
PEEK Nut
(Unlatched) (Latched)
c
CPU Socket
a
(a, b, c, d: Threaded Fasteners)
B
Rotating Wire 4
D
b
d
CPU Socket
1U Heatsink
40
b
CPU Socket Pin1
Rotating Wire 2
Heatsink (Top Side)
Rotating Wire
C
Rotating Wire
A
PEEK Nut
c
a
3
1