Supermicro X13DEG-PVC User Manual page 116

Super X13DEG-PVC User's Manual
Support Aggressive Link Power Management (Available when "SATA Controller(s)"
is set to Enabled)
When this feature is set to Enabled, the SATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
SATA SGPIO Mode (Available when "SATA Controller(s)" is set to Enabled)
Select Enabled for Serial_Link General Purpose I/O (SGPIO) Mode support.
LED and SGPIO.
SATA Port 0 - SATA Port 7 (Available when "SATA Controller(s)" is set to Enabled)
Note: The SATA port naming may vary based on the related configuration.
Hot Plug
Select Enabled to support Hot-plugging for the device installed on a selected SATA port to
allow you to replace the device installed in the slot without shutting down the system. The
options are Disabled and Enabled.
Spin Up Device
Select Enabled for Staggered Spin Up support to allow the SATA devices specified by the
user to spin up one at a time upon at bootup in an effort to prevent all hard drive disks
from spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
PCH SATA2 Configuration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following features.
SATA Controller(s)
This feature enables or disables the onboard SATA controller(s) supported by the Intel PCH
chip. The options are Enabled and Disabled.
116
The options are