Supermicro X13DEG-PVC User Manual page 140

Super X13DEG-PVC User's Manual
NIC Configuration
Link Speed
Use this feature to set the connection speed of a LAN port specified by the user. The options
are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
If this feature is set to Enabled, the LAN port specified by the user will be enabled when
the system is powered on. The default option is N/A.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED indicators.
The default setting is 0 (up to 15 seconds).
The following information is displayed:
•
UEFI Driver
•
Adapter PBA
•
Device Name
•
Chip Type
•
PCI Device ID
•
PCI Address
•
Link Status
•
MAC Address
•
Virtual MAC Address
Intel(R) Ethernet Controller 10 Gigabit X540-AT2 - (MAC address)
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on you
system configurations.
NIC Configuration
Link Speed
Use this feature to set the connection speed of a LAN port specified by the user. The options
are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
140