Table of Contents
Advertisement
Super X13DEG-PVC User's Manual
Boot Retry Count
Use this feature to control the number of retries to attempt in case of boot failure. The
options are No Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries, 5 Retries, 6 Retries, and
Indefinite Retries.
Boot Strap Type
Use this feature to control the boot strap method used to boot to the operating system.
The default option is Int 19h.
Pkey
Use this feature to configure the Pkey ID to be used by PXE boot. The valid range is 0 -
64435. The default setting is 0.
iSCSI Configuration
Boot to Target
Use this feature to specify whether the iSCSI initiator will boot to the specified iSCSI target
after connection. One Time Disabled disables iSCSI boot for the next (current) boot after
it is enabled. The options are Disabled, Enabled, and One Time Disabled.
TCP/IP Parameters via DHCP
Use this feature to controls the source of the initiator IPv4 IP address, DHCP or static
assigment. The options are Disabled and Enabled.
iSCSI Parameters via DHCP
Use this feature to enable the acquisition of iSCSI target parameters from DHCP. The
options are Disabled and Enabled.
CHAP Authentication
Use this feature to enable the initiator to use CHAP authentication when connecting to the
iSCSI target. The options are Disabled and Enabled.
CHAP Mutual Authentication (available when "CHAP Authentication" is set to
Enabled)
To use mutual CHAP authentication, specify an initiator secret on the Initiator Parameters
page and configure that secret on the target. The options are Disabled and Enabled.
IP Version
This option displays whether IPv4 or IPv6 network addressing will be used for iSCSI initiator
and targets.
146
Advertisement
Table of Contents
