Table of Contents
Advertisement
Chapter 4: UEFI BIOS
Media Auto Detect
Select Enabled to enable the firmware auto detect capability of the link transceiver. If the
DAC cable supports Auto-negotiation, then both Auto-negotiation and forced speeds are
enabled. The options are Disabled and Enabled.
Default EVB Mode
Use this feature to configure the default Edge Virtual Bridging Mode. The options are VEB,
VEPA, and None.
Default EVB Mode
Select Enabled to enable PME Capability support for the system. The options are Disabled
and Enabled.
Flow Offload
Select Enabled to enable Flow Offload Mode for the system. This feature is supported on
Linux DPDK only. The options are Disabled and Enabled.
Live Firmware Upgrade
Select Enabled to enable of device firmware upgrade with minimal downtime and traffic
interruption. This feature is supported on Linux OS only. The options are Disabled and
Enabled.
Adapter Error Recovery
Select Enabled to enable firmware recovery from fatal error without manual intervention,
host reboot, and power cycle. The options are Disabled and Enabled.
Device Configuration Menu
Option ROM
Select Enabled to enable Boot option ROM for the system. The options are Disabled and
Enabled.
Legacy Boot Protocol
Use this feature to set a non-UEFI network boot protocol. The options are PXE, iSCSI,
and None.
Boot Strap Type
Use this feature to set Boot Strap Type for the system. The options are Auto Detect, BBS,
Int 18h and Int 19h.
Hide Setup Prompt
Use this feature to configure whether Setup Prompt is displayed during ROM initialization.
The options are Disabled and Enabled.
135
Advertisement
Table of Contents
