Table of Contents
Advertisement
Boot Retry Count
Use this feature to configure link up delay time in seconds. The valid range is 0 - 255. The
default setting is 0.
Use TCP Timestamp
Select Enabled to enable the use of TCP timestamp. The options are Disabled and Enabled.
Target as First HDD
Select Enabled to enable the target appears as first hard disk drive (HDD) in the system.
The options are Disabled and Enabled.
LUN Busy Retry Count
Use this feature to configure the number of retries in 2 second intervals when LUN is busy.
The valid range is 0 - 60. The default setting is 0.
Boot Retry Count
Use this feature to set IP version support. The options are IPv4 and IPv6.
iSCSI Initiator Parameters
IP Address
Use this feature to configure the initiator IP address.
Subnet Mask
Use this feature to configure the IP subnet mask.
Default Gateway
Use this feature to configure the default gateway IP address.
Primary DNS
Use this feature to configure the primary DNS IP address.
Secondary DNS
Use this feature to configure the secondary DNS IP address.
iSCSI Name
Use this feature to configure the iSCSI name.
The following firmware family version information is displayed:
•
CHAP ID
•
CHAP Secret
137
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
