Table of Contents
Advertisement
Super X13DEG-PVC User's Manual
Legacy Boot Protocol
Use this feature to set a legacy network boot protocol. The options are None, PXE, iSCSI,
PXE without faile-over, and iSCSI without fail-over.
IPv4/IPv6 support
Use this feature to select whether IPv4 or IPv6 network addressing will be used for iSCSI
initiator and targets. The options are IPv4, IPv6, and IPv4/IPv6.
Virtual LAN Mode
Select Enabled to enable Virtual LAN mode. Virtual LAN mode enables use of a VLAN tag
to be used by PXE. The options are Disabled and Enabled.
Virtual LAN ID (available when "Virtual LAN Mode" is set to "Enabled")
Use this feature to set the VLAN ID used in the PXE VLAN mode by entering a value
ranging from 0 to 4094. The default setting is 1.
Boot Retry Count
Use this feature to control the number of retries to attempt in case of boot failure. The
options are No Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries, 5 Retries, 6 Retries, and
Indefinite Retries.
Boot Strap Type
Use this feature to control the boot strap method used to boot to the operating system.
The default option is Int 19h.
iSCSI Configuration
Boot to Target
Use this feature to specify whether the iSCSI initiator will boot to the specified iSCSI target
after connection. One Time Disabled disables iSCSI boot for the next (current) boot, after
which it is enabled. The options are Disabled, Enabled, and One Time Disabled.
TCP/IP Parameters via DHCP
Use this feature to controls the source of the initiator IPv4 IP address, DHCP or static
assigment. The options are Disabled and Enabled.
iSCSI Parameters via DHCP
Use this feature to enable the acquisition of iSCSI target parameters from DHCP. The
options are Disabled and Enabled.
CHAP Authentication
Use this feature to enable the initiator to use CHAP authentication when connecting to the
iSCSI target. The options are Disabled and Enabled.
142
Advertisement
Table of Contents
